# Water Extraction Tempe AZ | Water Damage Tempe

> Water extraction in Tempe, AZ removes standing water fast, mapped with moisture readings before mold sets in — a written scope before any work starts.

URL: https://waterdamagetempe.com/water-extraction-tempe-az/

## Price

$2,251-$2,313 for a full restoration job. this reflects a typical full water-damage-restoration job in Tempe, not extraction alone — based on Homeyou's Tempe-specific average of $2,251-$2,313, with a separate 2025 Maricopa County estimate slightly higher at $2,290-$2,418; the broader range cited across sources runs $1,200-$7,600 depending on the water category and square footage affected. Category 1 (clean water) work runs closer to $3-$4/sq ft, Category 3 (black water) closer to $7-$7.50/sq ft — extraction itself is one phase of that total, priced within the scope we write up on the first visit, not as a separate flat fee.

## What's included

- Truck-mount or portable extraction to remove standing water fast
- Moisture readings taken and logged across floors, subfloor, and walls to map how far the water traveled
- Water category identified — clean, gray, or black — before extraction begins
- Carpet, pad, and flooring assessed for what can be dried in place versus what has to come out
- Baseboards pulled and weep holes drilled where needed so trapped water can escape wall cavities
- Structural drying equipment set immediately after extraction, so the two phases run back to back
- Time-stamped photos and moisture logs handed over for your records or an insurance claim
- Written scope and price before any work beyond the assessment starts

## Process

01. **Call and describe the situation** - Tell us what happened — a burst pipe, appliance failure, slab leak, or storm intrusion — and we book a free on-site assessment, day or night.
02. **Identify the water category** - We determine whether it's Category 1 (clean), 2 (gray), or 3 (black) water before extraction starts, since that determines the safety and disposal requirements for everything that follows.
03. **Extract and map the moisture** - Standing water is removed with truck-mount or portable extraction equipment while we take moisture readings across floors, subfloor, and walls to find water that migrated out of sight.
04. **Hand off to structural drying** - Once the bulk water is out, drying equipment goes in immediately — extraction and drying are sequential phases of the same job, not two separate services you have to schedule twice.

## When it's needed

- Standing water visible on flooring after a pipe burst, appliance failure, or storm intrusion
- Carpet or pad that stays wet or squishes underfoot hours after the source is stopped
- A warm spot on tile or an unexplained damp patch — a possible sign of a slab leak
- Water intrusion after a monsoon storm through a flat or low-slope roof
- A washing machine, water heater, or dishwasher failure that released standing water

## FAQ

**How is water extraction different from structural drying?**

Extraction removes standing and trapped water with pumps and vacuums — it's the first phase. Structural drying is the second phase, using air movers and dehumidifiers to pull remaining moisture out of framing, subfloor, and drywall until the structure reads dry. We treat them as sequential steps on the same job, not two separate services.

**How fast do you need to start extraction after a pipe bursts?**

As soon as possible — mold can begin colonizing water-damaged material within 24-48 hours, and the longer clean water sits, the more likely it degrades toward a gray-water classification. Speed is the single biggest factor in how much of the structure and flooring can be saved versus replaced.

**Can water extraction happen if the source is a slab leak?**

Yes, but the leak itself needs a plumber to stop it — we extract and dry the resulting damage, and coordinate with a plumber (yours or a referral) on the under-slab repair. Extracting water without stopping the source just means doing it again.

**Do you extract water from carpet, or does it have to be pulled up?**

It depends on how long the water sat and what category it is. Clean water caught quickly can often be extracted and dried in place with carpet and pad intact; water that sat longer, or any Category 2/3 water, usually means the pad — and sometimes the carpet — comes out. We tell you which situation you're in during the on-site assessment.